News

Frequent replacement of forklift tires is not a good thing. It is not only time-consuming but also causes a lot of waste. So Zhejiang Kunrong Rubber Technology Co., Ltd. hereby reminds you to use forklifts reasonably, which not only saves time and effort, but also ensures long-term safety/safety work. A guarantee, let's take a look: How to reduce the wear of forklift tires?






 
1. Strengthen the maintenance of tires.
Do a good job of land survey and pressure cleaning, check the temperature of the tires, and the grounding holes are blocked.
Usually when inflating tires, if it is cold and under a certain load, regularly check and adjust the tire pressure at least once a month; in summer, due to the high ambient temperature, if the tire temperature is too high, reduce the frequency of increase to avoid strong sunlight to the tires , it is recommended to stop in the shade of a tree, instead of directly pouring cold water for cooling or directly venting to reduce pressure. If you are going to leave it in the open parking lot for a long time in winter, you should base it on the tires and don't start accelerating immediately until the tires get hot, and then it becomes normal driving.
 
2. Improve driving skills.
Lift the clutch pedal slowly and steadily when starting off. The maximum speed of driving must not exceed the speed limit of the tire; it should be avoided as much as possible during the process of rapid acceleration, emergency braking and sharp turning. In the case of obstacles such as rocks and potholes, it is recommended that you slow down as much as possible or avoid it directly.

3. Improve the maintenance of the chassis.
Lubricate and adjust the design value of wheel hub bearing, tie rod ball end, king pin bushing in time according to regulations; keep the balance of the tire, if it is unbalanced, the wheel dynamic balance test should be used to exhaust the one-way valve frequently, and the tire has been oiled. Once the forklift is found Tire into oil, you should immediately remove the tire to clean, and check the air seal at the same time, replace the tire winter tire in the greenhouse to restore / restore elasticity / elasticity, load the rim forklift tire product Apply soap in the fetal port to prevent damage to the port; pivot oil Sealing and brake hydraulic cylinders should be leak-free, and oil- and wet-resistant rubber tires should meet the requirements for lateral and radial swinging wheel assemblies.